Ratoc Systems USB2.0 PCI Host Board REX-PCIU2 Bedienungsanleitung

PCIU2User’s ManualJune 2001Rev.1.0USB2.0 PCI Host Board

1014. To verify that the driver is installed correctly, right-click on [My Computer], select [SystemProperties], and then select the [Device Manager]

113-3. Installing the driver(Windows 2000)Before you install the driver, make sure Windows 2000 Service Pack2 or later is already installed .To verify

123. Select [Specify a location] and click [Next].4. The following dialog box will appear.Type in [E:\PCIU2] and click [OK]. (E means

138. To verify that the driver is installed correctly, right-click on [My Computer], select [SystemProperties], and then select the [Hardware] tab. Th

142. Select [RATOC PCI USB Enhanced Host Controller] and click [OK].3-4. Installing the driver(Windows Me)When you use Windows Me, follow the steps to

15NOTEYou may find the [RATOC PCI USB Enhanced Host Controller] string with green ? marks.But this doesn’t affect the peformance of this PCIU2 board.5

164-1. How to RegisterWe highly recommend to register yourself as our customer through our on-line registration.1. On the Internet, access our site (h

17Option is available (sold separately) at the web site:1. http://www.ratocsystems.com/english/2. http://www.firewireshop.com-USB2-01

18Model NameBoard TypePCI Bus transferUSB data transfer rateEnvironmentUSB connectorUSB port correntOptional connectorUSB 2.0 Type A x 2port 500mA a

19Copyright©2001 RATOC Systems,Inc. All rights reserved. No part of this publication may be reproduced, store in a retrieval system, or transmitted in

2Contents1. Introduction... 3 1-1. Features...

3 •Supports 480Mbps(High-speed), 12Mbps(Full-speed), 1.5Mbps(Low-speed) data transfer mode. This USB2.0 host adapter is fully backwards compati

42. Before installing...2-1. Package Check the package contents: •PCIU2 PCI Board •Low profile bracket •Software CD-ROM •User’s manualNOTEIf

5After installing it, start your PC. Then, you need to install the driver for the PCIU2.A)When you use Windows 98SE----------- Proceed to Chapter 3-2.

63-2. Installing the driver(Windows 98SE)When you use Windows 98SE, follow the steps to install the driver.1. When you start your PC after installing

74. Select [The updated driver(Recommended) NEC USB Open Host Controller] and click[Next].5. Click [Next].6. Click [Finish].7. The same hardware wizar

810. Select [Specify a location] and type in [D:\PCIU2] and click [Next]. (D means your CD-ROM drive letter. If your CD-ROM is “E”,

911. Make sure Windows found the PCIEHCI.INF file in the PCIU2 folder in the CD-ROM drive.Then, click [Next].12. Click [Finish].13. Restart your PC.